Configure your Dispenser

The "SELL" option will not be available on your BATMThree or BATMFour unless you have banknotes to dispense. This article provides instructions to setup your dispensers.

To configure a Recycler, please see: Recycler Loading & Unloading.

Your BATM must be successfully connected to (and active on) a server to proceed!

First, load your banknotes into a dispenser cartridge:

Orient them with the same face & direction.

TIP: Dispenser problems?

We recommend you place 5-10 blank paper “slugs” (or $1 bills) above the actual banknote stack to increase the height, and thus improve the pickup capabilities of the dispenser feed rollers underneath.

The dispenser will only dispense the banknotes you tell it exist, so don’t include the slugs in the count. e.g. if you insert 50 banknotes + 5 “slugs”, only set the cassette quantity to 50!

Access the ADVANCED administration screen on your BATM. Instructions.

Reinsert the stacker/cashbox after the screen appears.
Select CASHBOXES

Press CONFIGURE CASHBOXES

Set the denomination & quantities for each cassette.

Configure CAS settings

Login to CAS.
Navigate to Crypto Settings
Configure the SELL option for at least one Crypto Setting to see a "SELL" option on your BATM.

Reject Tray

Banknotes that fail to pass the dispenser’s physical validation process during issuance may be rejected. You can locate these rejects in the green-handled tray above the cassettes and below the ejection slot.

Ejected banknotes are counted in Terminal: Cash, see: Cash

General Bytes Knowledge Base