Recycler Configuration, Loading & Unloading

Some of our two-way BATMs come with a Recycler. Very useful, it accepts up to 2 denominations of banknotes, which it can then also dispense to your customers. Unlike a simple cash dispenser, it does force you to jump through a few extra hoops, though. A Recycler is recommended for lower volume locations where 2-way operation is desired, but substantial amounts of cash on-hand is unnecessary.

  1. The Recycler must be manually loaded, one banknote at a time.

  2. The Recycler must be specifically unloaded.

  3. To purge the Recycler, use “Float Down”: Recycler Float Downs

When the Recycler fills to capacity of any particular banknote, it will pass further banknotes through to the stacker (cashbox).


IMPORTANT:

The Recycler must be emptied prior to updating your acceptor firmware!

  • Recyclers use special firmware, and installing non-recycler firmware may damage it.

BE SURE TO SPECIFY THAT YOU USE A RECYCLER WHEN REQUESTING NEW BILLSET FIRMWARE!

Configuring your Recycler

Access the ADVANCED administration screen. Instructions.

  • Reinsert the stacker/cashbox after the screen appears.

  • Select CASHBOXES

Configure your Recycler (if you haven’t already):

  • Press CONFIGURE CASHBOXES

  • Press RECYCLER - CASHBOXES

  • Set the denominations for each drum (2 drums).

  • Click OK and proceed to load the Recycler.


Loading your Recycler

  • Press LOAD RECYCLER.

  • The acceptor LED will light up solid green.

  • Insert up to 54 banknotes of each of the 2 denominations selected.

  • Orient the bills in the same face & direction!


Unload your Recycler

In some instances, you may wish to reduce the number of a selected banknotes. Unloaded banknotes are deposited into the stacker (cashbox).

  • Press "Unload Recycler" and specify the denomination & quantity of banknotes.

  • The banknotes will be unloaded into the stacker/cashbox.

Copyright © 2020-2024 General Bytes USA LLC