Recycler Configuration, Loading & Unloading

Some of our two-way BATMs come with a Recycler. Very useful, it accepts up to 2 denominations of banknotes, which it can then also dispense to your customers. Unlike a simple cash dispenser, it does force you to jump through a few extra hoops, though. A Recycler is recommended for lower volume locations where 2-way operation is desired, but substantial amounts of cash on-hand is unnecessary.

The Recycler must be manually loaded, one banknote at a time.
The Recycler must be specifically unloaded.
To purge the Recycler, use “Float Down”: Recycler Float Downs

When the Recycler fills to capacity of any particular banknote, it will pass further banknotes through to the stacker (cashbox).

IMPORTANT:

The Recycler must be emptied prior to updating your acceptor firmware!

Recyclers use special firmware, and installing non-recycler firmware may damage it.

BE SURE TO SPECIFY THAT YOU USE A RECYCLER WHEN REQUESTING NEW BILLSET FIRMWARE!

Configuring your Recycler

Access the ADVANCED administration screen. Instructions.

Reinsert the stacker/cashbox after the screen appears.
Select CASHBOXES

Configure your Recycler (if you haven’t already):

Press CONFIGURE CASHBOXES

Press RECYCLER - CASHBOXES

Set the denominations for each drum (2 drums).
Click OK and proceed to load the Recycler.

Loading your Recycler

Press LOAD RECYCLER.
The acceptor LED will light up solid green.
Insert up to 54 banknotes of each of the 2 denominations selected.
Orient the bills in the same face & direction!

Unload your Recycler

In some instances, you may wish to reduce the number of a selected banknotes. Unloaded banknotes are deposited into the stacker (cashbox).

Press "Unload Recycler" and specify the denomination & quantity of banknotes.
The banknotes will be unloaded into the stacker/cashbox.