Payment Card Reader CAS Configuration

Currently, two different card reader vendors are supported in CAS.

Choose the reader you’re installing from this list to navigate to that specific Terminal configuration. The remainder of this guide is common to both variants:

• Worldline Valina

• QpayPOS Q5000

• Common Instructions

Worldline Valina

Hardware installation on a BATMThree: https://generalbytes.atlassian.net/wiki/x/AQDo4

• https://support.worldline.com/content/dam/support-worldline/local/en-ch/documents/flyers/110042102-FL-TIM-INT-EN-1705081.pdf

For each Terminal that has a Valina installed:

1. Add the EUR fiat.

2. Set the Terminal’s AML/KYC to use EUR.

3. Set your Terminal’s “Payment Card Reader Settings” to use the hardware-defined protocol:

   1. Worldline Valina - TIM (default protocol): set the Card Reader ID *

      1. Payment Card Reader ID = eight digits unique to each card reader.

      2. These digits are labeled as a “TID#” on the device.

   2. Worldline Valina - CTEP (no further CAS configuration required).

4. CTEP configuration ON THE VALINA (when used instead of TIM):

   1. Press the M button on the back of the device 5 times.

   2. Select “Configuration”.

   3. Select “Technician Menu”.

   4. Input the password.

   5. Check the device has correct IP address set in “Network Interface” → “Ethernet” → “IP address” (must be on the same network/router as the BATM).

   6. Go to POS Integration.

      1. Pick CTEP Protocol, press OK.

      2. Pick TCP/IP Client, press OK.

      3. Set POS IP address to the BATM IP address.

      4. Set POS port number to 9000.

      5. Leave the menu.

   7. Reboot the BATM.

   8. The Debit/Credit card reader should now correctly initialize during BATM startup.

QpayPOS Q5000

QpayPOS web page for the Q5000: https://qpaypos.es/eu/q5000/

Hardware installation on a BATMFour: https://generalbytes.atlassian.net/wiki/spaces/ESD/pages/3773366273

Setup Instructions

For each Terminal that has a Q5000 installed:

1. Add the EUR fiat.

2. Set the Terminal’s AML/KYC to use EUR.

3. Set your Terminal’s “Payment Card Reader Settings” to use “QpayPOS Q5000”.

Common Instructions

Activate in AML/KYC settings:
Enable the checkbox for card payments in each supported AML/KYC setting for the affected Terminal(s).

• See: https://generalbytes.atlassian.net/wiki/spaces/ESD/pages/966656131/AML+KYC+Settings#Enable-card-payments

Open

• Save for each tier (as appropriate).

• Save the AML/KYC setting.

Reporting

After the first card transaction, a new section “payment_card_terminal” will appear in the Cash report:

Open

Clicking “SHOW TRANSACTIONS” on that page will now generate a card (only) transaction report:

Open

Banknote History will now also list card payments (in the payment_card_terminal Cash Box):

Open

An example of a card purchase at the BATM:

Open

Hardware Installation Instructions