Printer Articles

This section contains all articles that relate to printer setup & troubleshooting.

EP802.png

User Manual:


3D print a replacement EP-802 spindle cap:

Recommended settings for printing is:

  • Reduce model size by 2%, for tight fit on the shaft!!!

  • Material with high yield strength (such as PETG).

  • Any layer height (use the one with best adhesion for your printer).

  • Perimeters 4-6 - or at least 1mm thick wall.

  • Bottom and top shell at least 0.7mm thick.

  • Infill between 50% to 100% grid (100% linear).

  • No supports or rafts needed.

  • Download the STL here:

Copyright © 2020-2024 General Bytes USA LLC