1. Cycle the power on the BATM (off/wait 5 seconds/on).
...
2. Open the Administration screen. Instructions.
Warning |
---|
If the touchscreen won't respond, see the instructions at the bottom of this article to install a mouse temporarily. |
3. Select "CALIBRATE":
...
4. Choose the "9 points calibration":
...
5. Press each target and hold your finger for several seconds.
6. Test the touchscreen calibration. Repeat steps 2-5 as needed.
7. If using a mouse, unplug the mouse & reinsert the Fingerprint Scanner.
8. Reboot the BATM. Verify that the touchscreen & fingerprint scanner works.
Note |
---|
IF YOU CANNOT PRESS THE ICON TO ENTER ADMINISTRATIVE MODE
|
...