/
BATMThree Touchscreen Calibration

BATMThree Touchscreen Calibration

1. Cycle the power on the BATM (off/wait 5 seconds/on).

2. Open the Administration screen. Instructions.

If the touchscreen won't respond, see the instructions at the bottom of this article to install a mouse temporarily.

3. Select "CALIBRATE":

4. Choose the "9 points calibration":

 

5. Press each target and hold your finger for several seconds.

6. Test the touchscreen calibration. Repeat steps 2-5 as needed.

7. If using a mouse, unplug the mouse & reinsert the Fingerprint Scanner.

8. Reboot the BATM. Verify that the touchscreen & fingerprint scanner works.

IF YOU CANNOT PRESS THE ICON TO ENTER ADMINISTRATIVE MODE

  • Please unplug the Fingerprint Scanner (USB port #4 - see map below).

  • Replace it temporarily with a USB mouse.

 

Related content

BATMThree Touchscreen Inspection
BATMThree Touchscreen Inspection
More like this
BATMTwo Components
Read with this
BATMFour QPay Q5000 Card Reader Installation
BATMFour QPay Q5000 Card Reader Installation
More like this
Product & Parts Returns
Product & Parts Returns
Read with this
Door Sensor Installation
Door Sensor Installation
More like this

Copyright © 2020-2024 General Bytes USA LLC