...
Info |
---|
Other messages might be displayed (depending on version):
|
Your BATM connects to the server (CAS) over the Internet using an encrypted and secure channel. To identify itself to the server, the BATM presents a pre-authorized fingerprint to the server. If this fingerprint changes for any reason, the server will refuse to converse with the BATM, and the error message above will be displayed. You should also note the error in the affected Terminal’s Event Log.
...
.
Pairing will fail after a 10 minute window has expired.
Turn the BATM “on” and connect to CAS within ten minutes of an attempted pairing.
The authorization process is called "pairing", and is a discrete step performed when the BATM is put into service. Typically, this process is only done once, and is automatic that first time only.
Tip |
---|
This is a security measure.
|
Something changed, and now you see this message. Don't fret. This is easily resolved in one of two ways:
...
From CAS:
1. Navigate to your Terminal.
2. Click “Unpair Terminal”:
...
From the CLI:
1. Note the BATM serial number (e.g. BT101308) for step 3 (serialno).
2. Tell CAS to forget the old fingerprint:
Code Block |
---|
sudo /batm/batm-manage terminal-unpair serialno |
3. Turn the BATM back on.
Tip |
---|
After booting, the BATM will again attempt to connect to CAS.
|
...
Note |
---|
Troubleshooting
|
Note |
---|
On older CAS versions (pre-2021): is your Shared Secret Hash properly set in the Terminal settings?
|
...