...
Allow it to restore the factory installed firmware image.
...
Create a “Restore Point” to enable the firmware image to be updated at the BATM.
Restore Points will also restore your server & connection settings.
A Restore Point will overwrite the factory installed image, so only create a Restore Point when you’re certain the BATM performance is stable & proven.
Unless you’ve previously created a Restore Point, the BATM will be in a “new” state. No data is stored in the BATM - so no data is lost, however you will need to setup the BATM again as though it were brand new. This includes:
...
This highly intermittent problem will only occur after rebooting your BATM. For this reason, we discourage routine (especially scheduled) reboots. Please don’t reboot unless you need to!
Please advise Support if this problem recurs.
Create a “Restore Point” to enable the firmware image to be updated at the BATM.