The BATM Alarm is programmed remotely using SMS messages.
Tip |
---|
You must program the Alarm before deploying it. |
Alarm Name
The Alarm Name is used as an identifier which is sent with every outgoing SMS message to you.
Alert Recipients
The Alarm will send notifications to listed (and approved) recipients.
Recipients receive notifications when an alarm has been triggered.
Recipients have permission to arm & disarm.
Note:
We recommend limiting your Alert Recipients to a minimum.
Each outgoing SMS takes about 5-10 sec depending on signal strength, GSM network traffic, etc.
The alarm cannot receive AND send SMS messages simultaneously.
While sending an SMS it is not possible to receive an SMS until all outgoing alerts are completed, so incoming SMS commands will be delayed.
If there aren’t many alerts to send, the alarm will respond more quickly.
Alert Recipients will receive a notification from the alarm after being successfully “added”.
Warning |
---|
Any attempt to save more than 10 telephone numbers (aggregate),
|
Every removed telephone number is sent an SMS text:
"This number will be removed from BATM ALARM " ( + the Alarm Name )
Related articles
Filter by label (Content by label) | ||||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
Page Properties | ||
---|---|---|
| ||
|