...
a short video demonstrating the problem.
a picture of your BATM3 Administration page:
3D print a replacement EP-802 spindle cap:
Recommended settings for printing is:
...
Reduce model size by 2%, for tight fit on the shaft!!!
...
Material with high yield strength (such as PETG).
...
Any layer height (use the one with best adhesion for your printer).
...
Perimeters 4-6 - or at least 1mm thick wall.
...
Bottom and top shell at least 0.7mm thick.
...
Infill between 50% to 100% grid (100% linear).
...
No supports or rafts needed.
...
Related articles
| Filter by label (Content by label) | ||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
...