...
the custom cover plate from GB designed specifically for the reader installation on the BATMFour,
the USB reduction for the data connection, and
basic mounting fasteners.
Obviously, you’ll also need a QPay Q5000 (not sold or included by GB).
Installation steps
Prepare your Q5000 card reader. The devices have a number code on the back - and while technically not required for installation - we recommend that you note which serials are in which terminals for future reference. The code on the reader won't be visible once the installation is done.
Insert the Q5000 terminal into the rubber spacer as shown in the picture.
| Info |
|---|
The rubber spacer is supplied by QPay with the Q5000 on demand.
|
...
Place the reader display down (onto a suitable surface so as not to scratch it) and place the custom plate onto the reader.
...
Align the mounting holes with the thread in reader. Use the USB-C cutout for roughing out the position.
...
Remove only the top-most (original) plate (leave the distance plate installed).
...
Install the
...
custom Q5000 cover plate.
Prepare your Q5000 card reader. The devices have a number code on the back - and while technically not required for installation - we recommend that you note which serials are in which terminals for future reference. The code on the reader won't be visible once the installation is done.
Insert the Q5000 terminal into the rubber spacer as shown in the picture.
| Info |
|---|
The rubber spacer is supplied by QPay with the Q5000 on demand.
|
...
Position the upgrade custom metal plate with the Q5000 installed in place, and refasten the 10 serrated nuts that we removed earlier (minus 1 unusable nut located in the corner).
Before tightening them, wiggle the metal cover plate a little bit to ensure it is fully seated.
Be gentle with the torque used to tighten these nuts, we recommend 2,3 Nm as the maximum limit. If overtightened, the screws will make indentations on the visible side of the upgrade cover plate.
...