...
the custom cover plate from GB designed specifically for the reader installation on the BATMFour,
the USB reduction for the data connection, and
basic mounting fasteners.
Obviously, you’ll also need a QPay Q5000 (not sold or included by GB).
Installation steps
Place the reader display down (onto a suitable surface so as not to scratch it) and place the custom plate onto the reader.
Align the mounting holes with the thread in reader. Use the USB-C cutout for roughing out the position.
...
Use the supplied screws and washers to attach the reader (there is 1 spare of each). Do not tighten them individually, rather start ALL and THEN tighten them together.
...
Gently tighten the 4 screws. DO NOT OVERTIGHTEN. The device nuts are encased in plastic. You only need to ensure that the reader is not loose. If you overtighten these screws, you may damage the reader.
...
...
| Warning |
|---|
Be sure to remove power to the BATM before performing any maintenance on the BATM. |
...
| Info |
|---|
The rubber spacer is supplied by QPay with the Q5000 on demand.
|
...
Place the reader display down (onto a suitable surface so as not to scratch it) and place the custom plate onto the reader.
Align the mounting holes with the thread in reader. Use the USB-C cutout for roughing out the position.
...
Use the supplied screws and washers to attach the reader (there is 1 spare of each). Do not tighten them individually, rather start ALL and THEN tighten them together.
...
Gently tighten the 4 screws. DO NOT OVERTIGHTEN. The device nuts are encased in plastic. You only need to ensure that the reader is not loose. If you overtighten these screws, you may damage the reader.
...
Position the upgrade custom metal plate with the Q5000 installed in place, and refasten the 10 serrated nuts that we removed earlier (minus 1 unusable nut located in the corner).
...