This guide demonstrates how to install Ethernet for your Internet connection on a BATM4BATMFour.
1. Remove the cable port
...
plate:
...
Use the 7mm nut driver (provided with the BATM) to remove the 2 nuts.
Feed the cable through the now exposed hole.
Replace the plate, reversing the notch, to hold the Ethernet cable.
...
3. Remove the controller cover plate.
...
4. Run the cable to the controller - avoid
...
power cables & pinch hazards.
...
6. Replace the control area cover plate to it’s original location.
5.
...
Apply power, boot the BATM & test the Ethernet connection.
...
Do not use WiFi with Ethernet - the two may compete & produce unpredictable results.
...
Related Information:
| Filter by label (Content by label) | ||||||||
|---|---|---|---|---|---|---|---|---|
|