...
You are now ready to integrate the enclosure into the BATM.
...
Mount the Enclosure
Place the drilling template onto the BATMThree, so that the exposed cylinder lock will fit into the cutout in the template.
...
Dint (mark) the holes with a center punch. This step is critical, please follow these recommendations.
Do not yet perforate the sidesteel.
Compare the dint location to the drilling template.
If you can see bare metal while looking perpendicularly through the drilling template, you are in the correct spot. Proceed.
...
Deburr holes as needed.
Clean the area and vacuum any metal pieces from the inside of the BATM.
...
Secure the enclosure to the BATM with the provided M5 screws.
Route the cables internally as necessary, considering the location of your router.
Pay attention to the components attached to the top door.
Carefully close the top door to ensure you are not pinching any cables.
...