...
You are now ready to integrate the enclosure into the BATM.
...
Mounting
Take Place the drilling template and place it onto the BATMThree, so that the exposed cylinder lock will fit into the cutout in the template.
...
Dint (mark) the holes with a center punch. This step is critical, please follow these recommendations.
Do not yet perforate the side.
Compare the dint location to the drilling template.
If you can see bare metal while looking perpendicularly through the drilling template, you are in the correct spot. Proceed.
...
Drill holes into the marked positions. This step is critical, please follow these recommendations
Use the dints to guide the final drill locations (7mm bit recommended).
| Note |
|---|
Cover any internal electronic devices (e.g. acceptor) from the metal burrs that may fall into them. Failure to do so may result in short circuits and electronics damage! Use a vacuum cleaner to remove any debris before applying power. |
Drill a small (3mm bit) dint (do not yet perforate) and compare its location to the drilling template.
...
If you can see bare metal while looking perpendicularly through the drilling template, you are in the correct spot.
...
. |
...
Drill a hole for the cable.
...