This guide demonstrates how to install Ethernet for your Internet connection on a BATM4.
1. Remove the port cover plate:
...
Use the 7mm nut driver (provided with the BATM) to remove the 2 nuts.
Feed the cable through the now exposed hole.
Replace the plate, reversing the notch, to hold the Ethernet cable.
| Note |
|---|
WARNING: do NOT pinch the Ethernet cable. |
2. Feed the cable & reattach the plate (reverse the notch).
...
75cm (about 30 inches) length of internal cable should suffice.
A few zippy ties will work well as strain relief. Use 2 or more zippy ties (as needed).
Don’t overtighten the zippy ties, knot, or pinch the cable.
3. Remove the controller cover plate.
...
4. Run the cable to the controller - avoid any power cables.
...