This guide demonstrates how to install Ethernet for your Internet connection on a BATMFour.
1. Remove the cable port
...
plate:
...
Use the 7mm nut driver (provided with the BATM) to remove the 2 nuts.
Feed the cable through the now exposed hole.
Replace the plate, reversing the notch, to hold the Ethernet cable.
...
4. Run the cable to the controller - avoid power cables & pinch hazards.
...
6. Replace the control area cover plate to it’s original location.
5.
...
Apply power, boot the BATM & test the Ethernet connection.
...
Do not use WiFi with Ethernet - the two may compete & produce unpredictable results.
...
Related Information:
| Filter by label (Content by label) | ||||||||
|---|---|---|---|---|---|---|---|---|
|